It is used to cast concrete beam. The basic beauty of our systems is as below.
- Eco friendly
- More repetition than rubber coated, plywood & M S plate i.e. more than 100 repeat
- Labour friendly as it is light is weight, i.e. 6 to 7 time less than M S & half than plywood, Easy to Fix, dismantle, Carry and transport.
- Cost saving: As the finishing of our concrete work is so finished that one need not to do plaster. One can simply put lapi & paint & able to save Rs. 16/- per Sq.feet.
- Quality of beam: The quality of beam will be much better as concrete material cannot stick to our surface, plus Cement & water will not waste by coming & consume in plates beam will be cure from all sides without wastage of cement.
- Easy to Install: Light in weight, No need of nails & binding wire, Auto leveling by plug
- Easy to maintain: Only flush the water & you can clean.
- Easy to repair for reuse simple low voltage, low cost plastic welding can do repairing
- 300 x 530 mm plate, 150 x 150 x 530 mm, 230 x 300 mm, 300 x 300 mm plate, 150 mm dia plug & locking system can be used as per requirement.
- As product manufactured by injection moulding process. All corner are at <90 and site are Straight and parallel so no gap will be developed during installation and use so no water and cement mortar leakage will be happed
- Unadjusted gap can be set with 12mm plywood sheet easily as there is gap of 12mm between plug and plate.
- Beam depth and width is adjustable in 3”steps. width can be adjust from minimum 9” to maximum any. Depth can be adjustable maximum up to 24”.
